Professional Cable Tray Manufacturer

Shandong Hongfeng Electric Group Co., Ltd.

The products can be widely used in construction, energy, power, plant.

How many meters of the length of the cable tray can be radians

Release time:

2023-12-12

The question of how long a straight section of the bridge can bend in radians

The question of how long a straight section of the bridge can bend in radians defines how many meters of the length of the bridge can do radians?
Radian takes horizontal 90 degrees as an example, then this question can be understood as how many meters it takes for a straight-through cable tray to be transformed into a horizontal curved cable tray. To answer this question, the length of the straight-through cable tray before the transformation can be deduced from the horizontal bend.
The calculation method of the straight curve of the bridge is as follows: the horizontal bend of the bridge is divided into several parts: the length of the horizontal bend is divided into several parts, and the diagram is as follows: length 1 indicates the length of the part of the bridge to be connected with other bridges, and it is also the part of the fixed connecting piece, length 2 represents the length of the right-angled side of the curved curved edge of the bridge, and length 3 indicates the width of the bridge if the horizontal bend is changed into the corresponding straight-through.
The minimum length corresponding to the straight-through is (length 1 + length 2 + length 3) * 2, that is, the outside of the bend is re-straightened.
The length of the straight section of the bridge with different sizes can be bent. There is no fixed standard for the bridge, which depends on the size of the bridge.
For example, according to the above formula length = (120-100-100) * 2=640mm, that is, the straight-through bridge of 100-50 can do a 90-degree horizontal bend of 100-50, such as the bridge of 200-100, according to the above formula length = (120-100) * 2=840mm, that is, the straight-through bridge of 200-100 can do the 90-degree horizontal bend above length 1 and length 2 of 20000100 are the specified dimensions of the bridge products.
From the above calculation results, it can be concluded that the larger the width of the bridge, the longer the length required to make the bend of the corresponding radians.

Keywords：

National standard for the thickness of cable tray and what is the influence of thickness on cable tray

Introduction of relevant specifications and standards for cable tray

National standard for the thickness of cable tray and what is the influence of thickness on cable tray

Introduction of relevant specifications and standards for cable tray